Maintenance points of Omron relay
Published:2023-02-01 15:32:10
1. The shell surface of the Omron relay used in installation should be free of scratches, cracks and damage. In case of serious damage, the intact relay with the same specifications should be replaced in time;
2. In the maintenance process of Omron relay, it is necessary to check whether the contact of Omron relay is broken or bright. If abnormal situation is found, maintenance personnel should timely deal with it;
3. Carefully check whether there are foreign bodies such as welding slag and dust inside the Omron relay to avoid affecting the performance of the relay;
Four. Check whether the coil inside the Omron relay is broken, but also check whether all the connections are broken, whether the solder joint is full and wet;
5. Because the pin of relay is easy to be damaged, it is necessary to check regularly whether the pin of Omron relay has deformation, discoloration or other mechanical damage;
Vi. Check whether the fastener of Omron relay is loose. If the above phenomenon is found, the maintenance personnel should tighten it in time;
Vii. In the actual use of Omron relay, the locating pin and the base may loosen under certain circumstances, so it is necessary to check whether the locating pin and the base are consistent and whether they are loose. In the process of inspection, if loose phenomenon is found, corresponding measures should be taken in time.

-
202302-15What symptom does WEINVIEW touch screen motherboard malfunction have?
1. The motherboard cannot recognize/display peripheral devices.2. Peripherals will stop working for a few seconds or more.3. A slow startup may indicate that your motherboard is broken, although it co···
-
202302-23The solution of Schneider inverter fault code
PHF: ⒈ Frequency converter power supply is not correct or fuse is blown; B. There is momentary defect in some phase. ⒈ Check the power supply connection and fuse; B. Reposition.USF: ⒈ Supply voltag···
-
202302-06Siemens Soft Starter 3RW44 can self-reset can be fault
Not all faults can be self-reset. The faults that can be self-reset are as follows (The method of self-reset is to set the corresponding parameters in the menu of the LCD screen) :1) Motor thermal mod···
-
202302-07WEINVIEW TK6070ih touch screen into the system setting what are the methods?
1. Generally, there is a small black arrow button in the lower right corner of the touch screen. After clicking and entering the correct password, you can enter the system Settings. However, during co···
-
202301-31Influence of Delta impulse current on frequency converter
In the process of maintenance of frequency converter, it is found that due to the back electromotive force in the stator winding, the electromotive force in the motor under the condition of synchronou···

+86 13811814778
+86 13811814778
Building 26, Liyuan Community, Chaoyang District, Beijing, China